Revision as of 21:11, 4 October 2011 by Stevechewbacca (Talk | contribs)
crlblackhd.gif
Snow Trooper Commander
500px
Model unknown, Photo by unknown


Blizzard-Force.png

Description: Snow Trooper Commander
Prefix: TS
Detachment: Blizzard Force
Context: Star Wars Episode V: The Empire Strikes Back
These troopers wear special cold weather gear for hostile climates


The 501st approval requirements are listed in black.

The Blizzard Force Detachment defines additional, optional costuming details listed in blue. Please visit the Blizzard Force web site for more details on these options.

For 501st membership only the requirements in black need to be met.


  • This CRL is a work in progress.
  • This costume may be approved by GMLs, but until the library entry is complete, it is suggested that this character first be submitted to the appropriate DL/GML peer review section of the legion forum.
  • If you have this costume and would like to assist with the completion of this library entry, please contact your detachment leader.
  • Please note that the use of the word "should" below does not indicate that the armor piece is considered open to interpretation. All instances of "should be" and "should have" will be replaced with "is" and "has", as this guide is completed.
Composants de Costume Requis

Les composants de costumes suivants doivent être présents et apparaître comme décrit ci-dessous pour l’approbation.

TS commander helmet.jpg Casque
For 501st approval:
  • Plastique moulé ou fibre de verre correspondant aux mêmes couleurs que l'armure.
  • Lentilles plates et vert foncé
  • Imperial disk greeblie (Doit avoir 2 marches UNIQUEMENT)
  • Protection du visage en plastique dur.
For level two certification (if applicable):
For level three certification (if applicable):


TS duster.jpg Duster
For 501st approval:
  • White / Off-White in color
  • Must be made of a medium to heavy weight material that "pills" after wear.
  • Should extend down to at least the tops of the boots but no further than the top of the ankle.
  • Corners of the duster are rounded.
  • Should include belt loops for belt.
For level two certification (if applicable):
For level three certification (if applicable):
TS commander chest.jpg Chest Armor
For 501st approval:
  • rank bar two red squares over two blue (2 red squares on top)
  • recessed area contains 2 gray squares on left 1 gray over 1 red on right 2 gray horizontal lines separate squares.
  • Blue Pinstriping on left side of chestpate.
  • 2 shoulder straps connected to the top of the chestplate.
For level two certification (if applicable):
For level three certification (if applicable):
TS commander back.jpg Back Armor
For 501st approval:
  • back armor (white) with various details as shown
For level two certification (if applicable):
For level three certification (if applicable):
TS commander shoulderbell.jpg Shoulder Armor
For 501st approval:
  • Shoulder plates have the raised boxes to the top.
  • Shoulders plates are connected directly to the duster
For level two certification (if applicable):
For level three certification (if applicable):
TK anh stunt forearms.jpeg Forearms
For 501st approval:
  • Forearms are fully closed.
For level two certification (if applicable):
For level three certification (if applicable):
Blankwhite.gif Gloves and Handplates
For 501st approval:
  • Snowtrooper style handplates are sewn directly to the gloves.
  • Gray or White leather gloves with a 4-6 inch cuff.
    • The brand name WELDAS SOFTOUCH Tig/Mig gloves appear to be the closest to the screen used gloves.
    • White Damascus D650 Gauntlets or White/Grey Fencing gloves are a perfectly acceptable alternative.
  • The left glove cuff has a small commpad on it, approx 1.5" x 1.5" with the outer section slightly curved, and the inner section straight. The Commpad has a circular centre section about 3/4" high, and topped with a small silver disk, slightly smaller than the centre section in diameter.
For level two certification (if applicable):
  • Clear Raised buttons in a row along the flat side of the commpad, four or five in total.
For level three certification (if applicable):
TS belt.jpg Ab Plate / Belt Buckle
For 501st approval:
  • Belt passes through slots on narrowed sections on the side.
  • A silver or gray button must be in the center.
  • Belt Buckle may be worn with sloped section up or down, however the button piece must be placed so the single dot is toward the angled side and the two dots are towards the straight side.

Belt is 2 inches wide and can be made of cloth, nylon strap or leather.

For level two certification (if applicable):
For level three certification (if applicable):
TK anh stunt detonator.jpeg Detonator
For 501st approval:
  • This is a gray cylinder 2 to 2.5" in diameter with white end caps and a white control panel pad, with controls closest to the right end cap.
  • Detonator is centered on the back of belt.
For level two certification (if applicable):
For level three certification (if applicable):
TS pouches.jpg Pouches
For 501st approval:
  • Pouches are rectangular and boxy with an angled flap.
  • Pouches secure to belt through loops on the back of each pouch.
For level two certification (if applicable):
For level three certification (if applicable):
TS pants.jpg Pants
For 501st approval:
  • White / Off white pants required
  • Acceptable examples are karate gi pants, "Dockers" or Painter pants, and US Army Cold Weather over-pants.
  • No pockets, zippers or buttons should be visible when trooper is standing at attention. Covering of these items by the cod and/or duster is acceptable.
For level two certification (if applicable):
For level three certification (if applicable):
TS cod.jpg Cod Piece
For 501st approval:
  • To be worn UNDER the duster
For level two certification (if applicable):
For level three certification (if applicable):
TS knees.jpg Knee Armor
For 501st approval:
  • Knee armor is worn with the curved edge toward the top.
For level two certification (if applicable):
  • Secured with straps on knee plates wrapping around the back of the leg.
For level three certification (if applicable):
TS commander boots.jpg Boots
For 501st approval:
  • White, Off white or light blue “moon” boots.
For level two certification (if applicable):
For level three certification (if applicable):
Accessoires Optionnels

Les items ci-dessous sont des accessoires optionnels du costume. Ces items ne sont pas requis pour l’approbation, mais si présents ils doivent respecter les directives ci-dessous.


Generic-dl44.jpg DL-44 Blaster Pistol
For 501st approval:
  • Fait de zéro ou bien une réplique aux finitions parfaites.



Crl-genericholster.jpg Holster
For 501st approval:
  • Couleur et style appropriés pour l'arme utilisée.
  • Ne doit pas être présent si aucune arme n'est portée avec le costume.


Personal tools
The 501st Legion is a worldwide Star Wars costuming organization comprised of and operated by Star Wars fans. While it is not sponsored by Lucasfilm Ltd., it is Lucasfilm's preferred Imperial costuming group. Star Wars, its characters, costumes, and all associated items are the intellectual property of Lucasfilm. © & ™ Lucasfilm Ltd. All rights reserved. Used under authorization.