(Difference between revisions)
(Created page with "{{CRLheader|Darth Traya|File:Missingprofile.jpg|none|nonei}} {{CRLdetinfo| 1115 |Darth Traya|SL|Star Wars Expanded Universe|}} {{CRLwiplmoapproval}}")
(7 intermediate revisions not shown)
Line 1: Line 1:
-
{{CRLheader|Darth Traya|File:Missingprofile.jpg|none|nonei}}
+
{{CRLheader|Darth Traya|File:SL_traya_full.jpg|SL-1956|Kelvin Kittrell}}
-
{{CRLdetinfo| 1115 |Darth Traya|SL|Star Wars Expanded Universe|}}
+
{{CRLdetinfo| 1115 |Darth Traya|SL|Star Wars Expanded Universe| Darth Traya, previously known as Kreia, was a Sith Lord during the second Sith War. She first trained the Jedi who went on to become Darth Revan, and then the Sith Lords Darth Nihilus and Darth Sion. }}
{{CRLwiplmoapproval}}
{{CRLwiplmoapproval}}
 +
 +
{{CRLrequirements}}
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_robe.jpg|Hooded Robe |
 +
*  The floor length, loose fitting robe is made of a matte black fabric.
 +
* The fabric is gathered at the shoulders to create a pleated look that runs down the front all the way from the shoulders to the floor.
 +
* The front of the robe is open from the shoulders to the belt, creating a "V" shaped opening.
 +
*  From the belt down, the robe is closed in front.
 +
*  The back of the robe is somewhat gathered, but it does not have the same pleating as the front.
 +
* The hood is attached to the robe, and has a pointed tip. When worn up, the hood falls directly over the bridge of the costumer's nose. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_hair.jpg|Headdress |
 +
* The headdress is made of black leather with red trim. It is fitted closely to the head, with the widow's peak "V" shape in the front coming to a point between the eyes, just above the bridge of the nose.
 +
* There is a red cabochon "jewel" set into the center of the headdress about 2 cm above the point.
 +
* The cabochon is smoothly rounded.
 +
* There are six openings edged in red that go across the top of the headdress.
 +
* A section of hair emerges from the third opening on each side of the headdress, creating a pony tail on each side of the face.
 +
* The headdress covers the costumer's ears, and for a secure fit it may fasten behind the head, under the hair. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_hairbands.jpg|Hair and Hair Bands |
 +
* The silvery white hair is long enough to reach the chest in front and the shoulder blades in the back.
 +
*  There are three black leather hair bands worn on each of the front ponytails.
 +
* The bands graduate in size from large at the top to smaller at the bottom.
 +
* There is a narrow strip of red trim on the top and bottom of each hair band. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_contacts.jpg|Contact Lenses |
 +
* Black contacts or full sclera lenses are worn to reproduce the solid black of Darth Traya's eyes.
 +
 +
* While considered an essential part of this character, contact lenses are not required for 501st acceptance. All persons wishing to utilize contact lenses are encouraged to first see their optometrist for a fitting. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_wimple.jpg|Wimple |
 +
* The wimple covers the costumer's cheeks, chin, and neck, and it is long enough to tuck into the high collar of the shirt or dress.
 +
*  The wimple is tight fitting and accentuates the costumer's cheekbones. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_makeup.jpg|Makeup |
 +
* Light colored makeup is used to create a pale skinned look.
 +
* The lipstick is dark grape or burgundy in tone.
 +
* There are pink toned shadows under the eyes.
 +
* A light charcoal gray color runs from the lashes lines to eyebrows.
 +
* The eyebrows are gray-black in tone, and are darker than the hair. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_shirt.jpg|Under Shirt or Dress |
 +
*  The dress or shirt worn under the robe is visible in the "V" opening at the front of the robe.
 +
* The fabric is a deeper shade of black than the outer robe.
 +
* The collar is a snug fitting turtleneck style.
 +
* If a shirt is used, ensure that it is long enough to stay securely tucked under the belt. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_glove.jpg|Glove |
 +
* A glove made of matte black material is used to disguise the "missing" left hand.
 +
* Alternatively, a special effects prosthesis may be worn to give the appearance of a (healed) forearm after the hand has been severed by a lightsaber. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_belt.jpg|Belt |
 +
* The belt is made of matte black leather and is approximately 7.5 cm wide.
 +
* The belt consists of three horizontal pieces. This effect may be created by joining three strips of leather, or by cutting or embossing two deep lines in a single strip of leather.
 +
* Two rectangular silver pieces adorn the center strip on the front of the belt.
 +
* The silver rectangles are approximately 2.5 cm tall and are divided into fourths. ||}}
 +
 +
 +
{{CRLtemplate-nolevels|File:SL_visas_boots.jpg |Boots|
 +
* The plain black boots have no visible buckles or laces.
 +
* The heels are low or flat. ||}}
 +
 +
 +
{{CRLaccessories}}
 +
 +
{{CRLtemplate-nolevels|File:SL_traya_saber.jpg|Lightsaber |
 +
* The lightsaber hilt is based on the KOTOR II style.
 +
* Darth Traya may carry from one to three lightsabers.
 +
* If bladed, the blade(s) are red or purple. ||}}
 +
 +
{{CRLfooter|Flagship_CRL|S}}

Revision as of 18:30, 22 December 2012

crlblackhd.gif
Darth Traya
SL traya full.jpg
Model SL-1956, Photo by Kelvin Kittrell


Flagship-Eclipse.png

Description: Darth Traya
Prefix: SL
Detachment: Flagship Eclipse Detachment
Context: Star Wars Expanded Universe
Darth Traya, previously known as Kreia, was a Sith Lord during the second Sith War. She first trained the Jedi who went on to become Darth Revan, and then the Sith Lords Darth Nihilus and Darth Sion.


  • This CRL is a work in progress.
  • As such, this costume must be approved by the Legion Membership Officer, via the appropriate section of the Legion forum.
  • If you have this costume and would like to assist with the completion of this library entry, please contact your detachment leader.
  • Please note that the use of the word "should" below does not indicate that the armor piece is considered open to interpretation. All instances of "should be" and "should have" will be replaced with "is" and "has", as this guide is completed.

Required Costume Components

The following costume components are present and appear as described below.

SL traya robe.jpg Hooded Robe
For 501st approval:
  • The floor length, loose fitting robe is made of a matte black fabric.
  • The fabric is gathered at the shoulders to create a pleated look that runs down the front all the way from the shoulders to the floor.
  • The front of the robe is open from the shoulders to the belt, creating a "V" shaped opening.
  • From the belt down, the robe is closed in front.
  • The back of the robe is somewhat gathered, but it does not have the same pleating as the front.
  • The hood is attached to the robe, and has a pointed tip. When worn up, the hood falls directly over the bridge of the costumer's nose.



SL traya hair.jpg Headdress
For 501st approval:
  • The headdress is made of black leather with red trim. It is fitted closely to the head, with the widow's peak "V" shape in the front coming to a point between the eyes, just above the bridge of the nose.
  • There is a red cabochon "jewel" set into the center of the headdress about 2 cm above the point.
  • The cabochon is smoothly rounded.
  • There are six openings edged in red that go across the top of the headdress.
  • A section of hair emerges from the third opening on each side of the headdress, creating a pony tail on each side of the face.
  • The headdress covers the costumer's ears, and for a secure fit it may fasten behind the head, under the hair.



SL traya hairbands.jpg Hair and Hair Bands
For 501st approval:
  • The silvery white hair is long enough to reach the chest in front and the shoulder blades in the back.
  • There are three black leather hair bands worn on each of the front ponytails.
  • The bands graduate in size from large at the top to smaller at the bottom.
  • There is a narrow strip of red trim on the top and bottom of each hair band.



SL traya contacts.jpg Contact Lenses
For 501st approval:
  • Black contacts or full sclera lenses are worn to reproduce the solid black of Darth Traya's eyes.
  • While considered an essential part of this character, contact lenses are not required for 501st acceptance. All persons wishing to utilize contact lenses are encouraged to first see their optometrist for a fitting.



SL traya wimple.jpg Wimple
For 501st approval:
  • The wimple covers the costumer's cheeks, chin, and neck, and it is long enough to tuck into the high collar of the shirt or dress.
  • The wimple is tight fitting and accentuates the costumer's cheekbones.



SL traya makeup.jpg Makeup
For 501st approval:
  • Light colored makeup is used to create a pale skinned look.
  • The lipstick is dark grape or burgundy in tone.
  • There are pink toned shadows under the eyes.
  • A light charcoal gray color runs from the lashes lines to eyebrows.
  • The eyebrows are gray-black in tone, and are darker than the hair.



SL traya shirt.jpg Under Shirt or Dress
For 501st approval:
  • The dress or shirt worn under the robe is visible in the "V" opening at the front of the robe.
  • The fabric is a deeper shade of black than the outer robe.
  • The collar is a snug fitting turtleneck style.
  • If a shirt is used, ensure that it is long enough to stay securely tucked under the belt.



SL traya glove.jpg Glove
For 501st approval:
  • A glove made of matte black material is used to disguise the "missing" left hand.
  • Alternatively, a special effects prosthesis may be worn to give the appearance of a (healed) forearm after the hand has been severed by a lightsaber.



SL traya belt.jpg Belt
For 501st approval:
  • The belt is made of matte black leather and is approximately 7.5 cm wide.
  • The belt consists of three horizontal pieces. This effect may be created by joining three strips of leather, or by cutting or embossing two deep lines in a single strip of leather.
  • Two rectangular silver pieces adorn the center strip on the front of the belt.
  • The silver rectangles are approximately 2.5 cm tall and are divided into fourths.



SL visas boots.jpg Boots
For 501st approval:
  • The plain black boots have no visible buckles or laces.
  • The heels are low or flat.



Optional Accessories

Items below are optional costume accessories. These items are not required for approval, but if present appear as described below.

SL traya saber.jpg Lightsaber
For 501st approval:
  • The lightsaber hilt is based on the KOTOR II style.
  • Darth Traya may carry from one to three lightsabers.
  • If bladed, the blade(s) are red or purple.


This document and all of the images within were created by and are the property of the 501st Legion. All other uses are prohibited.

This CRL is available as a PDF at www.501st.com/databank/Costuming:SL_traya

The 501st Legion is a worldwide Star Wars costuming organization comprised of and operated by Star Wars fans. While it is not sponsored by Lucasfilm Ltd., it is Lucasfilm's preferred Imperial costuming group. Star Wars, its characters, costumes, and all associated items are the intellectual property of Lucasfilm. ©2012 Lucasfilm Ltd. & TM. All rights reserved. Used under authorization.

Visit www.501st.com to learn more.
Personal tools
The 501st Legion is a worldwide Star Wars costuming organization comprised of and operated by Star Wars fans. While it is not sponsored by Lucasfilm Ltd., it is Lucasfilm's preferred Imperial costuming group. Star Wars, its characters, costumes, and all associated items are the intellectual property of Lucasfilm. © & ™ Lucasfilm Ltd. All rights reserved. Used under authorization.