Description: Juno Eclipse, Rogue Shadow
Prefix: ID
Detachment: Imperial Officer Corps
Context: The Force Unleashed

The 501st approval requirements are listed in black.

The Imperial Officer Corp Detachment defines additional, optional levels of costuming excellence. In the page below, items listed in blue are optional features that will improve the quality of the costume. These items are not required, but are recommended.

For 501st membership only the requirements in black need to be met.

For Level 3 approval, the combination of accessories for a costume must strictly match a particular movie seen configuration.

• This CRL is a work in progress.
• While this costume must be approved by the Legion Membership Officer, submissions should still go to the local GML, who will post the application in the appropriate section of the Legion forum.
• If you have this costume and would like to assist with this CRL, please contact your detachment leader!
• Please note that the use of the word "should" below does not indicate that a requirement is optional. All instances of should will be replaced with must as this guide is completed.

The following costume components must be present and appear as described below for approval .

• Fabric should be a medium weight suiting material exactly matching the pants and tunic if applicable. Gabardine style weave is most accurate.
• Base of the hat should be conical, with a crown about 4" (101.6 mm) tall.
• Front and rear "flaps" should overlap on the sides and be about 4" (101.6 mm) high.
• Front bill extends 3" down, decorated with 6 or 7 concentric stitches.
• Imperial Code Disk (see below) positioned in the center of the front vertical "flap."
  

• Code disk should have a notch detail on the outermost disk.

• Code disk should exactly match screen-used prop.

• Hair must be blonde. This can be achieved via natural hair color or a wig.
  

• A single row consisting of four amber chips and two red.
• Yellow chips are not acceptable.
  

• Please refer to the Imperial Buckle reference page for information on popular eBay available buckles.
• The belt shall be constructed from a non-textured leather or a leather-like material, approximately 2" (50.8 mm) in width (up to 3" (76.s mm) is acceptable)
• The buckle shall be constructed from a horizontally brushed metal, or metal looking material.
• A single large snap or rivet should be visible approximately 1" (25.4 mm) from the buckle. The belt may be worn with the snap to the right or left of the wearer.
• The buckle size should be approximately 2 5/8" (66.7 mm) high and 4 1/8" (104.5 mm) wide with 0.5" (12.7 mm) radius rounded corners.
• Buckles are adorned with an Imperial Code Disk at the center.