|
| Clone Captain Keeli
|
|
Model Brad White, Photo by CC-7396
|
|
|
|
Description: Clone Captain Keeli
Prefix: CC
Detachment: Clone Trooper Detachment
Context: The Clone Wars, season 3
Captain Keeli appeared in Season 3, Episode 3 "Supply Lines".
|
|
|
- This CRL is a work in progress.
- While this costume must be approved by the Legion Membership Officer, submissions should still go to the local GML, who will post the application in the appropriate section of the Legion forum.
- If you have this costume and would like to assist with this CRL, please contact your detachment leader!
- Please note that the use of the word "should" below does not indicate that a requirement is optional. All instances of should will be replaced with must as this guide is completed.
|
|
| Required Costume Components
|
|
The following costume components must be present and appear as described below for approval .
|
|
|
| Helmet
For 501st approval:
- Clone Wars style helmet required. Movie style helmets cannot be combined with animated armor.
- Base helmet must be painted matte or satin white. If weathered, the weathering should be shades of grey.
- Rust colored details as shown. For more photos, visit the Captain Keeli helmet detail page.
- Black visor extends down through the entire frown area.
- Narrow fin on dome.
- Raised bump at each ear, 1" - 1.25" in diameter.
- 4 Vents on each side of helmet. May be painted black or grey, or cut out and filled with black mesh.
- Primer grey stripe around back of dome.
- Raised white circle and rectangular white indent at the back of the helmet.
|
For level two certification (if applicable):
- Helmet must be weathered.
|
For level three certification (if applicable):
|
|
|
| Neck Seal
For 501st approval:
- Neck seal to be black in color with no ribbing. No logos or labels are to be visible. If the seal is not incorporated as part of the undersuit, a balaclava or other similar covering is acceptable.
|
For level two certification (if applicable):
- Neck seal should close via 2 small black snaps in the front.
|
For level three certification (if applicable):
|
|
|
| Under Suit
For 501st approval:
- Black non-textured material, either one-piece or two-piece construction with no visible zippers or logos.
|
|
|
| Shoulders
For 501st approval:
- Armor must be painted matte or satin white. If weathered, the weathering should be shades of grey.
- Shoulders should be padded so as not to sit flat against the arms. The top of the bell should sit 3/4" - 1" above the natural shoulder.
|
For level two certification (if applicable):
|
For level three certification (if applicable):
|
|
|
| Upper Arms
For 501st approval:
- Armor must be painted matte or satin white. If weathered, the weathering should be shades of grey.
- Armor has a notch on the lower area of the back of the arm that matches up with the elbow armor.
- Armor must be seamless. No visible traces of how the armor was assembled should be shown.
|
For level two certification (if applicable):
|
For level three certification (if applicable):
|
|
|
|
NAVIGATION
|
